Advertisement
Assembly
Step 7
Burner 2
Burner 3
Fig. 7B
Side Burner
Fig. 7C
Burner 3
Burner 2
Fig. 7A
Burner 1
Side Burner
Burner 1
10
Step 7: Installing the Control Panel As-
sembly
Locate: Fig. 7A shows the inside of the
Control Panel Assembly ( CP has (3) gas
valves mounted on a manifold connected
to the Hose, Side Burner Valve and Regu-
lator assembly (HVR). There is an Elec-
tronic Ignition assembly attached, which
has (4) igniter wires, of different lengths, to
attach to each burner tube and the Side
Burner and (4) M6x15 bolts.
Procedure: Refer to Fig. 7B and carefully
thread the HVR with the Side Burner ig-
niter wire through the opening in the front
face of the Grill, make a turn to the left and
bring it out through the opening in the left
side of the Grill. Allow it to hang free, as
we will later make the connection to the
Side Burner.
Refer to Fig. 7C, and note that at each
opening for the valve and burner connec-
tion, there is a small keyhole slot. The
Burners are numbered 1 to 3, starting with
# 1 as the Left Burner. Carefully push each
of the ignition wires through the holes to
dangle inside, resting in the keyhole slot.
The shortest wire is # 1 and the longest is
for # 3. We will attach these wires to each
burner tube when we install the burners.
Check to be certain that no wires have be-
come disconnected from the Igniter Hous-
ing.
Position the Control Panel in place against
the Front Panel and fasten it with (4)
M6x15 bolts from inside the Grill – see Fig.
7C
.
Advertisement
