Advertisement
Assembly
Step 11
Step 11: Assemble the Side Burner Gas
Fig.11A
Burner Unit
Locate: (1) Side Burner Housing ( already
attached to the Cabinet), Hose, Valve and
Regulator Assembly (HVR), Igniter with wire,
Burner assembly, (2) M4x8 screws.
Procedure:
Refer to Fig. 11A – Pick up the HVR and
Fig.11B
hold the Gas Valve in your hand and UN-
SCREW the (2) M4x6 screws.
Refer to Fig. 11B – Position the valve in
place between the front panel of the Side
Burner and the inner wall. Align the
threaded holes in the valve with the holes
in the Side Burner Housing and attach the
valve using the (2) M4x6 screws that were
Fig.11C
removed earlier.
Refer to Fig. 11C and insert the Burner and
Igniter assembly by passing the tube portion
DOWN from the top of the Housing into the
Housing. Then turn the Burner Assembly so
that the tube end is positioned completely
over the Gas Valve Tip.
Fig.11D
Refer to Fig. 11D and make certain that the
VALVE TIP is INSIDE the tube. Attach the
Burner Assembly to the Burner Housing with
(2) M4X8 screws from the UNDERSIDE of the
housing as shown.
Refer to Fig 11E and insert the Igniter Wire
into the burner electrode.
Fig.11E
13
Advertisement
