Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Saxby Lighting E27 LED GLS
Summary of Contents for Saxby Lighting E27 LED GLS
- Page 1 Instruction leaflet E27 LED GLS 70849, 70850, 70851...
- Page 2 Specification Voltage: 240V 50Hz Lamp: 10W LED E27 GLS - 800lm IP rating: 20 70849: 4 step dimming • Simply switch the light on and off to decrease the brightness of the bulb. Brightness levels shown here:- 70850: colour changing • When the light is first switched on the bulb is at 3000K brightness level. If the light is switched off and then on again, the brightness level of the bulb increases to 4000K. 70851: RGB • Battery care: Do not recharge non-rechargeable batteries. Do not mix old & new batteries or batteries of different types. Do not use rechargeable batteries. Always remove exhausted batteries from the remote control. Always insert the battery with the correct polarity. Do not short circuit the supply terminals. This product is suitable for use by adults only. • To replace the battery, release the compartment from inside the remote control by pushing the lever at the bottom left of the compartment. Pull the battery housing out and replace the exhausted battery with a new one - make sure the polarity is correct. Then slide the compartment back inside the remote control. • See below for further battery replacement info and instructions for use. Instructions for remote control Decrease brightness Increase brightness...
Need help?
Do you have a question about the E27 LED GLS and is the answer not in the manual?
Questions and answers