Table of Contents
Advertisement
G Post-alarm Recording (POST ALM
REC)
This setting specifies the duration of alarm recording after
an alarm input. Functions active during alarm recording are
buzzer beeping, ALARM LED indication, "ALARM" status
display, and the ALARM OUT signal.
1. Move the cursor to POST ALARM REC with the [D] or
[C] button.
2. Select the desired duration with the JogDial.
The default value is 10 seconds.
The unit will revert to the previous status when the time
has elapsed.
Available times (seconds): 5, 10, 20, 30
Available times (minutes): 1, 1.5, 2, 3, 6
Continue: Recording continues until the [REC STOP]
button is pressed, or the RESET IN signal is sup-
plied to the rear panel.
Manual: Recording continues for as long as the alarm
input is active, or at least for 10 seconds if the input
turns inactive earlier.
G Dynamic Recording (DYNAMIC REC)
This setting specifies the recording pattern on the disk
when one or more alarms operate.
1. Move the cursor to DYNAMIC REC with the [D] or [C]
button.
2. Select the parameter with the JogDial, and press the
JoDdial.
The default is OFF.
ALM-MULTI: Alarmed channels are recorded with pri-
ority over others.
OFF: All channels are recorded with the same priority.
G Trigger Action Setup (TRIGGER
ACTION SETUP)
This setting specifies the two roles of alarm recording and
alarm control functions (Refer to page 44) in the post-alarm
sequence.
TRIGGER ACTION SETUP
CAM
1
2
3
4
5
6
7
8
MODE
OFF
OFF
OFF
REC&ALM
REC
OFF
OFF
OFF
1. Move the cursor to TRIGGER ACTION SETUPO, and
press the JogDial.
The TRIGGER ACTION SETUP menu opens.
2. Move the cursor to the channel.
3. Select the parameter with the JogDial, and press the
JogDial.
The default is REC&ALM.
OFF: Disables alarm recording or warning.
REC&ALM: Enables both alarm recording and warning.
REC: Enables alarm recording, but disables warning.
4. Repeat steps 2 and 3 until all channels are set.
5. Press the [SETUP/ESC] button to return to the PROG1
SETUP, NO. 1 menu.
G Camera Recording Setup (CAM REC
SETUP)
This setting is provided for the purpose of saving disk
space. Setting allows each camera channel to be enrolled
in all recording modes or exclusively in alarm recording.
CAM REC SETUP
CAM
1
2
3
4
5
6
7
8
1. Move the cursor to CAM REC SETUP, and press the
[SET] button. The CAM REC SETUP menu opens.
2. Move the cursor to the camera channel with the [D] or
[C] button.
3. Select the parameter with the JogDial, and press the
JogDial.
The default is REC.
REC: The channel is recorded in alarm recording, timer
recording and manual recording mode.
ALM-ONLY: The channel is recorded only when the
alarm operates.
4. Repeat steps 2 and 3 until all channels are set.
5. Press the [SETUP/ESC] button to return to the PROG1
SETUP, NO. 1 menu.
MODE
REC
REC
REC
ALM-ONLY
REC
ALM-ONLY
REC
REC
27
Advertisement
Table of Contents
