Panasonic WJ-HD200 Operating Instructions Manual page 87

Digital disk recorder
Hide thumbs Also See for WJ-HD200:
Table of Contents

Advertisement

G When Full Indicator is Lit (Resetting
Disk End)
8 FULL Indicator
The FULL indicator will light up when STOP is set to
DISK END MODE, provided that the disk space nears
the end.
To reset it, do the following.
8 DISK END Setup
1. Hold down the [STOP] button for 2 seconds to open the
MAIN MENU.
WJ-HD200 MAIN MENU
TIMER
REC SETUPO
EXT REC SETUPO
DISPLAY SETUPO
SYSTEM SETUPO
ALARM SETUPO
COMMUNICATION SETUPO
SWITCHER SETUPO
SYSTEM INFORMATIONO
2. Select SYSTEM SETUP, and press the JogDial to open
the SYSTEM SETUP menu.
SYSTEM SETUP (1 OF 2)
PASSWORD LOCK
ALL→
OPERATION→
KEYLOCK BUZZ
SKIP ALM-RECALL
SIMUL REC&PLAY
ALTER DETECT
DISK END MODE
DISK END BUZZ
3. Move the cursor to DISK END MODE, and rotate the
JogDial to select CONTINUE. Then press the JogDial.
STOP: Stops recording at the disk end.
CONTINUE: Overwrites from the start of the disk.
4. Press the [STOP] button to return to the MAIN MENU.
5. Hold down the [STOP] button for 2 seconds to return to
normal operations.
The recorder starts operating in continuous mode up to
the disk end.
If you wish the recorder to revert to STOP for DISK END
MODE, repeat above steps 1 through 5, but select
STOP in step 3.
OFFO
OFF
*****
*****
OFF
5PAGE
ON
OFF
CONTINUE
ON
G When Error Indicator is Lit
Refer to your dealer for servicing when this happens.
8 HDD Check
The recorder checks the hard disk when the recorder is
turned on, or when the HDD CHECK time specified in
the menu setup comes during operation.
The recorder warns you of any error detected as fol-
lows.
Error indicator blinks.
Warning Out terminal on the rear panel turns active.
"NO DISK" will appear when there is no disk installed in the
recorder.
NO DISK
When this happens, turn off the power. New disk(s) should
be installed on the recorder, referring to INSTALLATION.
When Error Detected
8
1. Turn off the recorder, and turn it on again. It will perform
as follows.
DISK MENU is displayed.
Error indicator blinks.
Buzzer beeps every 5 seconds.
2. Press any buttons other than [STOP] to stop the indica-
tor blinking and buzzer beep.
3. See DISK MENU on the next page for further opera-
tions.
87

Advertisement

Table of Contents
loading

Table of Contents