Hilti TE 6-A36 Manual page 28

5.6 Fitting / removing the chuck
CAUTION
Risk of injury! The depth gauge, if fitted but not used, might hinder the operator.
▶ Remove the depth gauge from the tool.
▶ Fit / remove the chuck.
5.7 Inserting accessory tool
1. Lightly grease the connection end of the accessory tool.
▶ Use only genuine Hilti grease. Using the wrong grease can result in damage to the tool.
2. Push the accessory tool into the tool holder as far as it will go (until it engages).
3. After fitting the accessory tool, grip it and pull it in order to check that it is securely engaged.
▶ The product is ready for use.
5.8 Removing the accessory tool
▶ Pull the chuck back as far as it will go and remove the accessory tool.
5.9 Overhead work
▶ Fit the DCD dust control ring for overhead work.
5.10 Chisel positioning
▶ Set the function switch to the
22 English
6
7
8
position.
2100247
*2100247*