Hilti TE 6-A36 Manual page 27

Noise values
Sound power level (L
WA
Uncertainty for the sound power level (K
Emission sound pressure level (L
Uncertainty for the sound pressure level (K
Vibration values
Hammer drilling in concrete
(a )
h, HD
Vibration emission value, chis-
eling in concrete (a
h, Cheq
Uncertainty (K)
5 Operation
5.1 Preparations at the workplace
WARNING
Risk of injury by inadvertent starting!
▶ Before inserting the battery, make sure that the product is switched off.
▶ Remove the battery before making any adjustments to the power tool or before changing accessories.
Observe the safety instructions and warnings in this documentation and on the product.
5.2 Inserting the battery
CAUTION
Risk of injury! Inadvertent starting of the rotary hammer drill.
▶ Before installing the battery, check that the rotary hammer drill is switched off and that the forward/reverse
switch is in the middle position (i.e. switch-on interlock engaged).
1. Push the battery into the battery holder until it engages with an audible click.
2. Check that the battery is seated securely.
5.3 Removing the battery
1. Press the release buttons on the battery.
2. Pull the battery out toward the rear.
5.4 Fitting the side handle
CAUTION
Risk of injury! Loss of control over the product.
▶ Check that the side handle is fitted correctly and tightened securely. Check that the clamping band is
engaged in the groove in the product.
1. Release the side handle clamping band by turning the handle grip.
2. From the front, slide the depth gauge into the 2 guide holes.
3. Tighten the side handle clamping band by turning the handle grip.
5.5 Fitting and adjusting the depth gauge
▶ Fit the depth gauge, if necessary, and adjust it correctly.
*2100247*
)
)
WA
)
pA
)
pA
B 36/5.2
B 36/9.0
B 36/5.2
)
B 36/9.0
2
3
4
5
2100247
99 dB(A)
3 dB(A)
88 dB(A)
3 dB(A)
TE 6­A36
16.8 m/s²
16.2 m/s²
8.1 m/s²
7.5 m/s²
1.5 m/s²
TE DRS­6­A
12.7 m/s²
12.3 m/s²
•/•
•/•
1.5 m/s²
English 21