Hilti TE 6-A36 Manual page 25

Electrical safety
▶ Before beginning work, check the working area for concealed electric cables or gas and water pipes.
External metal parts of the product could give you an electric shock or cause an explosion if you
accidentally damage an electric cable or a gas or water pipe.
Power tool use and care
▶ Switch the product off immediately if the accessory tool jams. The product might twist off-line.
▶ Wait until the product has come to a complete stop before you lay it down.
2.4 Safety instructions
▶ Observe all safety instructions in this documentation and on the device.
▶ Use respiratory protection to keep residual dust away from the face and airways when drilling and when
servicing the tool or accessories.
▶ Always use the side handle on the Hilti rotary hammer drill, even when the dust removal module is fitted.
2.5 Careful handling and use of batteries
▶ Observe the special guidelines applicable to the transport, storage and use of lithium-ion batteries.
▶ Do not expose batteries to high temperatures, direct sunlight or fire.
▶ Do not disassemble, crush or incinerate batteries and do not subject them to temperatures over 80 °C
(176 °F).
▶ Do not use or charge batteries that have suffered mechanical impact, have been dropped from a height
or show signs of damage. In this case, always contact your Hilti Service.
▶ If the battery is too hot to touch it may be defective. Put the battery in a place where it is clearly visible
and where there is no risk of fire, at an adequate distance from flammable materials. Allow the battery to
cool down. If it is still too hot to touch after an hour, the battery is faulty. Contact Hilti Service.
3 Description
3.1 Product overview
3.2 Intended use
The product described is a cordless rotary hammer drill. It is designed for drilling in steel, wood and masonry,
for hammer-action drilling in concrete and masonry, and for driving and removing screws. The product can
also be used for light chiseling work on masonry and surface finishing on concrete.
▶ Use only Hilti Li-ion batteries from the B 36 series with this product.
▶ Use only the Hilti battery chargers from the C4/36 series for these batteries.
*2100247*
1
2100247
Dust shield
@
tool holder
;
Insert tool unlocking device
=
Depth gauge
%
Function selector switch
&
Forward / reverse switch with switch-on in-
(
terlock
Control switch
)
Grip
+
Battery release buttons
§
Charge status and fault display (Li-ion bat-
/
tery)
Battery
:
Connection for the TE DRS-6-A(02) dust re-
∙
moval module
Side handle
$
Light to illuminate the work area
£
English 19