Getting Started; Set Up The Neon ™ Nxt Electroporation System - ThermoFisher Scientific Invitrogen NEON1 User Manual

Getting started

Set up the Neon
1. Unpack the Neon
page 12.
2. Place the Neon
cm surrounding the unit to ensure proper ventilation.
Note: The Neon
hood for convenience.
IMPORTANT! Position the device properly such that the power switch and AC inlet located at the
rear of the unit (see "Front and rear view"
device such that it is easy to disconnect the unit.
Since Neon
installing the device, leave a space of more than 10 cm from the back of the device.
3. Place the Neon
4. Connect the high voltage and low voltage interface connectors on the cable to the high voltage
and low voltage interface ports at the rear of the Neon
IMPORTANT! Always handle the connectors using the cord plug and not the cord cable when
connecting or disconnecting the connectors.
Neon NxT Electroporation System User Guide
™
NxT Electroporation System
™
NxT Electroporation System as described in "Unpacking instructions"
™
NxT device on a level laboratory bench. Keep an area of free space at least 10
™
NxT device has a small footprint and can be easily set up in the tissue culture
™
NxT device is air-cooled, its surface may become hot during operation. When
™
NxT Pipette Station near the Neon
™
on page 9) are easily accessible. Be sure to position the
NxT device.
™
NxT Pipette Station.
™
Chapter 1 Product information
Getting started
1
on
13