Front Brake Master Cylinder - Suzuki RM250K4 Setup Manual

Fit the rubber cover onto the throttle housing.
A: Rubber cover

FRONT BRAKE MASTER CYLINDER

Remove the bolts and holder from the front brake
master cylinder.
A: Master cylinder
B: Holder
C: Bolt
Install the front brake master cylinder onto the han-
dlebars. Align the dot mark on the handlebars with
the master cylinder-to-holder fitting surface. Tighten
the master cylinder mounting bolts to the specified
torque.
" " Front brake master cylinder mounting bolt: " "
NOTE:
To install the holder correctly, first tighten the
bolt B B B B of the upper side with specified torque
and then tighten the bolt C C C C of the lower side.
A: Master cylinder
B: Bolt
C: Bolt
NOTE:
Install the holder in position according to the
mark "UP".
Make sure that the holder has no clearance at
the upper side as shown.
!
Check for brake fluid leakage.
A: Bolt
B: Holder
11
10 N·m (1.0 kgf-m)
D: Holder
E: Dot mark
C: Master cylinder
D: Handlebars