Front Brake Master Cylinder - Suzuki SVF650K9 Setup Manual


The line drawings on page 29, 30 and 31 show
the proper routing of the control cables, hose
and wirings.
Refer to them in addition to following the
instructions carefully.
A: Front brake hose
B: Throttle cables
C: Right switch wiring harness
D: Clutch cable
E: Left switch wiring harness
THROTTLE
Insert the boss of throttle housing into the hole on the
handlebars.
Install the throttle assembly with two screws.

Check to ensure that the throttle operates freely
and closes automatically.
A: Boss
B: Hole
C: 5 × 30 mm screw

FRONT BRAKE MASTER CYLINDER

Install the front brake master cylinder onto the handle-
bars.
Align the dot mark on the handlebars with the master
cylinder-to-holder fitting surface.
Tighten the front brake master cylinder mounting bolts
to the specified torque.
 Front brake master cylinder mounting bolt:
NOTE:
To install the holder correctly, first tighten the
bolt C of the upper side with specified torque
and then tighten the bolt D of the lower side.
A: Holder
B: Front brake master cylinder
C: 6 × 22 mm flange bolt
D: 6 × 22 mm flange bolt
E: Dot mark
7
10 N·m (1.0 kgf-m)