Microphone (Ssm-85D) - Yaesu FTM-500DR Operating Manual

Microphone (SSM-85D)

MIC
Speak into the microphone during transmission.
TX LED
Lights red while pressing PTT switch.
PTT
Press and hold the PTT switch to transmit, and re-
lease it to receive.
Press this key during the set mode to exit the set
mode.
DWN
• Press this button to move the frequency or mem-
ory channel lower by one step, press and hold it
to start scanning.
• On the memory channel list screen, press to se-
lect memory channels in 10 channel steps.
• On the Setup Menu screen, press to jump to the
previous category of the Setup Menu.
UP
• Press this button to move the frequency or mem-
ory channel up by one step, press and hold it to
start scanning.
• On the memory channel list screen, press to se-
lect memory channels in 10 channel steps.
• On the Setup Menu screen, press to jump to the
next category of the Setup Menu.
MUTE
Press this button to mute the receive audio. Press
it again to unmute the audio.
24
DTMF keypad
Press these keys during transmit to enter and send
a DTMF sequence. The following operations can
be performed during receive.
0 - 9 : Enter the frequency or memory channel
number.
A : No function assigned.
B : Each press switches between Main-band
and Sub-band.
C : Adjust the squelch level.
D : The band scope function operates.
: Each press switches between VFO mode
and memory mode.
# : This key has the same function as the
key on the controller.
VFO mode:
Each press changes the operating frequency band.
AIR  144MHz  VHF  430MHz  UHF
Memory mode:
Each time the key is pressed only memory chan-
nels of the same frequency band are automatically
recalled as a group, as shown below:
 
* Bands that have not been stored are not dis-
played.

 