Table of Contents
Advertisement
HPM-SRSUA User's Manual
VT-UTF8 Combo Key
Support
Recorder Mode
Resolution 100x31
Putty KeyPad
3.6.2.5 Option ROM Dispatch Policy
Item
Restore if Failure
Primary Video Ignore
Onboard Mass Storage Controller
50 HPM-SRSUA User's Manual
Disabled
Enabled[Default],
Disabled[Default],
Enabled
Disabled[Default],
Enabled
VT100[Default]
LINUX
XTERMR6
SCO
ESCN
VT400
Options
Disabled
Enabled[Default],
Disabled
Enabled[Default],
Enabled[Default],
buffers are full, a 'stop' signal can be sent to stop
the data flow. Once the buffers are empty, a
'start' signal can be sent to re-start the flow.
Hardware flow control uses two wires to send
start/stop signals.
Enable VT-UTF8 Combination Key Support for
ANSI/VT100 terminals.
With this mode enabled only text will be sent.
This is to capture Terminal data.
Enables or disables extended terminal resolution.
Select FunctionKey and KeyPad on Putty.
Description
If system fails to boot and this option is set to
'Enabled', software will reset settings of this
page as well as CSM page to its default values
automatically.
If software will detect that due to the Policy
settings. Option ROM of Primary Video Device
will not dispatch, it will ignore this device policy
settings, and restore it to 'Enable'
automatically.
Onboard Device has:
Advertisement
Table of Contents
