Table of Contents
Advertisement
8.1.1 IMPULSE
For IMPULSE·G+/VG+ drives, use the following parameter settings. Using the control signal outputs from
the Intelli-Protect controller, wire the permissive outputs to the Magnetek trolley, bridge and hoist drives.
Parameter
H01-05
H01-06
H01-07
H01-08
8.2 Hoist Upper Limit Switch
An optional Hoist Upper Limit input is available on the Power and Control Wiring terminal block for all
zones. Select the UI Zone Configuration checkbox "Hoist Upper Limit" to flyover the selected zone. This is
available on the single fixed location No-Fly Zone, or each configurable zone.
·G+/VG+ Series 4 Drive Programming
®
Value
A
B
C
D
Figure 8-2: Hoist Upper Limit Switch
Display
Upper Lmt 1 N.C.
Upper Lmt 2 N.C.
Lower Lmt 1 N.C.
Lower Lmt 2 N.C.
Function
Term S5 Select
Term S6 Select
Term S7 Select
Term S8 Select
Intelli-Protect User Manual
April 2023
Page 57 of 65
Advertisement
Table of Contents
