2.6 Laser Alignment Instructions
1. The factory default setting for the laser pointer in the menu is "Auto."
–
If the sensor does not detect a target, the laser pointer flashes at a frequency of approximately
1 Hz.
–
Perform the alignment at the maximum possible distance.
2. Align the sensor so that the red laser dot is as close to center of reflector as possible.
–
As soon as the distance measurement device has detected a target, the laser pointer flashes for
an additional two minutes before deactivating automatically.
–
Run the crane to test and verify the laser dot remains on the reflector for the entire span of
operation.
2.7 Fixed Location Installation: Windmill Switches
Intelli-Protect
Fixed Location systems utilize four-pole limit switches with trip arms mounted at desired
®
slowdown, stop, and protected zone boundaries.
Trip arms should be mechanically mounted according to the following guidelines to achieve the best
results.
Figure 2-7: Trigger Mounting
Intelli-Protect User Manual
April 2023
Page 21 of 65