Table of Contents
Advertisement
4.4.1 Load Size Consideration
When configuring the No-Fly Zone, the dimensions of the material being moved by the overhead crane
and hoist needs to be considered. The length and width of the largest materials being moved should guide
the design of the zone to allow enough distance for slow down zone, stop zone and protected zone. In
addition to the length and width, the height of the material needs to be taken into account for fly-over No-
Fly Zones when using the Hoist Upper Limit input or Machine Down input to insure proper clearance over
the top of the protected zone.
Figure 4-7: Load Size Consideration
Intelli-Protect User Manual
April 2023
Page 41 of 65
Advertisement
Table of Contents
