Authorized Use - probst BSZ-KH-7.5 Operating Instructions Manual

General
3 General
3.1

Authorized use

The device (BSZ-KH) is especially suitable for gripping and transportation of barrier walls (New Jersey-Profile)
with any carrier, like excavator, fork lift truck, or truck loading crane.
Only gripping goods with a maximum conical slope of 6° (in the area of gripping jaws) should be gripped.
The device is series equipped with:
When gripping of highly conical gripping goods
(> 6 ° inclination) causes a risk of slipping, only
slightly conical (up to 6 ° inclined) gripping goods
(concrete barrier walls) can be gripped with the
device BSZ-KH (Fig. 1 u. 2) .
(Greifbereich der Gummigreifbacken)
Abb. 1
The gripping and transportation of „transition
elements" and "starter and final elements" and
the like is not permitted!
Due to the design of these gripping goods a safe
and centric gripping is not possible at the load
center.
•
The device is only designed for the use specified in this documentation.
•
Every other use is not authorized and is forbidden!
•
All relevant safety regulations, corresponding legal regulations, especially regulations of the declaration
of conformity, and additional local health and safety regulations have to be observed.
Prior to every operation the user must ensure that:
•
The equipment is suited to the intended operation, the functioning and the working condition of the
equipment is examined, and the load is suitable to be handled.
Any doubts about instructions should be raised with the manufacturer prior to use.
ATTENTION: The use of this device is only permitted in proximity to the ground (→ chapter "Safety at
work").
5310.0424
•
Lifting eye for attaching to crane hook
•
Automatic release fort he fully automatic switch
over from „full" to „empty".
Fig.2
Transition element
V1
8 / 18
Fig.3
Starter and final element
GB