Lift; Figure 62: Removing A Dpc - Juniper MX240 Hardware Manual

MX240 5G Universal Routing Platform Hardware Guide
188

Figure 62: Removing a DPC

Removing the FPC Before Installing the MX240 Router without a Lift
To remove an FPC (see Figure 63 on page
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to an approved site ESD grounding point. See the instructions for your site.
Simultaneously turn both the ejector handles counterclockwise to unseat the FPC.
2.
Grasp the handles and slide the FPC straight out of the card cage halfway.
3.
Place one hand around the front of the FPC and the other hand under it to support it.
4.
Slide the FPC completely out of the chassis, and place it on the antistatic mat or in
the electrostatic bag.
CAUTION: The weight of the FPC is concentrated in the back end. Be
prepared to accept the full weight—up to 18 lb (8.2 kg)—as you slide the
FPC out of the chassis.
When the FPC is out of the chassis, do not hold it by the ejector handles,
bus bars, or edge connectors. They cannot support its weight.
189):
Copyright © 2019, Juniper Networks, Inc.