Mounting The Opener; Raising The Door; Install The Prongs Or Drum Adaptor - Automatic Technology DOMINATOR EasyRoller 14 Instruction Manual

6.5. Mounting the Opener

Fig. 6.5.1
(i)
Fig. 6.5.2a
Fig. 6.5.2b
Fig. 6.5.3
Slide opener
over door
axle
12
Dominator EasyRoller Instruction Manual

6.5.1 Raising the Door:

a.
b.
NOTE: If there is limited ceiling space to lift the door, the door
bracket may have to be removed. If this is required, when refitting the
door bracket , use the reference marks on the wall for correct position
Lift door
and ensure that it is secure to the wall and will support the door.
up, away
from wall
NOTE: For tight sideroom installations the door may have to be taken
and down
down.
onto prop
6.5.2 Install the Prongs OR the Drum Adaptor
Install the Prongs:
a. Remove the prong kit
(ii)
b. Connect the prongs to the internal gear as shown in Fig 6.5.2
OR
Install the Drum Adaptor:
a. Remove the U Shape Adaptor from the box.
b. Place the U Shape Adaptor
6.5.3 Mounting the Opener:
a. Remove the opener from the box.
b. Check the drive gear rotates freely, by pulling the string handle
1
c. Slide the opener over the door axle and into the drum of the
2
d. Push the opener in as far as possible (without interfering with
e. Raise the door off the door stand or suitable prop.
f. Lift up and over the door bracket and use your reference marks
5
4
3
g. Refit the U-bolt and nuts and tighten (Fig 6.5.4).
h. Remove the safety rope and door stand or prop.
i. Connect the power cort to a suitable powerpoint, but DO NOT
SWITCH ON.
Pull string
j. Secure the power cord away from any moving object (e.g the
down to
door) with the cable clip supplied.
disengage
k. With the opener still disengaged, pull the door up and down to
opener
make sure it runs freely.
NOTE: After Installation, ensure that parts do not extend over public
footpaths or roads.
When in position, remove the U-bolt (or bolts) and saddle from
the door bracket.
Lift the door up and away from the wall until clear of the door
bracket, before lowering the door to rest on the door stand or
prop. (Fig 6.5.1)
(i) (ii)
or
and secure it using fasteners supplied.
1
Fig 6.5.2 and secure it using the spring
4 3
, 2 x self tapping screws
down (there will be a click) to disengage opener. Then move
the forks from side to side by hand.
door as shown in Fig 6.5.3.
the curtain) SO ONE OF THE DOOR DRUM'S WHEEL SPOKES
IS BETWEEN THE OPENER'S DRIVE FORKS.
on the door bracket to position the door.
T i g h t e n
U-bolts
from the box.
on the drum wheel as shown in
5
and flat washers
2
and the hex head screw .
Fig. 6.5.4