Wireless Programming - Chamberlain SectionalLift Plus Installation And Operating Instructions Manual

WIRELESS PROGRAMMING (OPTIONAL ACCESSORIES)
26
Activate the opener only when door is in full view, free of obstruction and properly adjusted. No one
should enter or leave garage while door is in motion. Do not allow children to operate push
button(s) or transmitter(s). Do not allow children to play near the door.
NOTE: The transmitter(s) and wireless wall button supplied
with your opener are preprogrammed by the factory.
If you purchase additional transmitters, the garage door opener
must be programmed to accept the new transmitter code.
Program the Receiver to Match Additional Transmitter Codes:
Using the yellow "LEARN" Button
1. Press and Hold the button on the hand-held transmitter that
you wish to use (1).
2. Press and release the yellow "LEARN" button on the opener
(2).
3. Release the transmitter button when the opener light flashes.
It has learnt the code. If you release the transmitter button
before the opener light flashes, the opener has not learned the
code.
Now the opener will operate when the transmitter button is
pressed.
To Erase all Transmitter Codes
1. Press and Hold the yellow "LEARN" button on the opener until
the indicator LED goes ON, and continue holding for approx. 6
seconds, until the indicator LED goes out.
2. Release the button, all codes are now erased.
Wireless Keypad E840C
To set the keyless entry PIN:
1. Locate the yellow "LEARN" button on the garage door opener.
2. Press and release the yellow "LEARN" button. The LED
indicator light will glow steadily.
3. Enter a 4-digit personal identification number (PIN) of your
choice on the keypad.
4. Press and hold the ENTER button. Check to see if the opener
light flashes. Release the ENTER button after the light flashes.
To change an existing keyless entry PIN:
1. Enter the existing programmed PIN that you want to change.
2. Press and hold the # button until the courtesy light flashes
twice.
3. Enter the new 4-digit PIN of your choice, then press the
ENTER button. The light will flash once.
4. To test, enter the new PIN, then press the ENTER button. The
garage door opener will activate.
PROGRAMMING
1
2
3
3
4
17
2
Yellow "Learn" Button
Locate
the yellow
learn button
Press and
release
the yellow
learn button
Enter a 4-digit
PIN of your
choice
? ? ? ?
_ _ _ _
Press and hold
the enter button
Opener light flashes
After the lights
flash release
the ENTER button
1