Panasonic AQUAREA WH-ADC0912K6E5AN Service Manual page 96

12.4.2.7 Network Adaptor 5 Installation (Optional)
1. Remove the Control Board Cover ⑤, then
connect the cable included with this adaptor to
the CN-CNT connector on the printed circuit
board.

Pull the cable out of the Tank Unit so that
there is no pinching.

If an Optional PCB has been installed in the
Tank Unit, connect to the CN-CNT connector
of the Optional PCB.
2. Insert a flat head screwdriver into the slot on
the top of the adaptor and remove the cover.
Connect the other end of the CN-CNT cable
connector to the connector inside the adaptor.
Slot
3. Pull the CN-CNT cable through the hole in the
bottom of the adaptor and re-attach the front
cover to the back cover.
Connector
CN-CNT cable
(Take care not to
pinch the cable)
4. Fix the Network Adaptor 5 to Network
Adaptor Holder.
Guide the cable as shown in the diagram so that
external forces cannot act on the connector in the
adaptor.
Connection examples:
Without Optional PCB
With Optional PCB
96
CN-CNT cable
CN-CNT cable
Network
Adaptor
Holder
Network
Adaptor
Holder