Appendix - Panasonic AQUAREA WH-ADC0912K6E5AN Service Manual

12.4 Appendix

12.4.1 Variation of System
This section introduces variation of various systems using Air-To-Water Heatpump and actual setting method.
(NOTE) : For this model, both external room thermistor of Zone 1 and external room thermostat of Zone 1 must
always be connected to main indoor PCB only regardless of Optional PCB (CZ-NS5P) connection.
12.4.1.1 Introduce Application Related to Temperature Setting
12.4.1.1.1 Temperature Setting Variation for Heating
1. Remote Controller
Outdoor Indoor
Connect floor heating or radiator directly to the Tank Unit.
Remote controller is installed on Tank Unit.
This is the basic form of the most simple system.
2. Room Thermostat
Outdoor
Indoor
Connect floor heating or radiator directly to the Tank Unit.
Remove remote controller from Tank Unit and install it in the room where floor heating is installed.
This is an application that uses remote controller as Room Thermostat.
Floor heating
Tank Unit receive Room Thermo signal (ON/OFF) from Remote controller
to control HP and circulation pump.
There is a build-in thermistor in the remote controller.
Floor heating
84
Setting of remote controller
Installer setting
System setup
Optional PCB connectivity - No
Zone & Sensor:
Water temperature
Setting of remote controller
Installer setting
System setup
Optional PCB connectivity - No
Zone & Sensor:
Room thermostat
Internal