Description Of Display - MicroStep SH-HC30 System Manual




7.3 Description of Display


 The first one: C: the capacitance detector mode, U: the arc voltage detector mode.
 The second one: no operation, flash between
 The last 3 digits: in the capacitance mode, a decimal; unit: of mm; in arc voltage

 Editing parameter status: The first one displays the parameter name; the second one
Page 24
SH-HC30 Height Controller System Manual
 Enter key: enter or exit the editing state.
 Function key: in the manual state, implement the function of "a key height
calibration"; in the editing state, switch the current editing parameters.
 Up arrow: in manual and automatic state, the set height value plus 1; in the
editing state, the current parameter plus one.
Down arrow: in manual and automatic state, the set height value minus 1; in the
editing state, the current parameter minus 1.
Display: the display functions are as follows:
1. Manual operation status: Display detector mode, operation status, set value of
height.
2. Automatic operational state: display detector mode, running state, the current
height value.
3. Editing parameter status: Display the editing parameter names and the
corresponding editing parameter values.
Manual operation state: The first one displays the detection mode; the second one
displays the operation state; the last 3 digits display the set value of height.
falling: .
mode, there is no decimal place; unit: V.
Automatic operation state: The first one displays the detection mode (as shown
above); the second one displays the operation state; the last 3 digits display the set
value of height (as shown above). The second one is described as follows:
When is the fixed display, the cutting torch is adjusted up at high speed.

When is the flashing display, the regulating speed of the cutting torch is

increased.
When is the fixed display, the cutting torch is adjusted down at high

speed.
When is the flashing display, the regulating speed of the cutting torch is

reduced.
When is the flashing display, the cutting torch is adjusted to the place.

When the last 3 digits are

alarm
When the last 3 digits are

alarm
When the last 4 digits are

When the last 4 digits are

displays the equal sign
flashing mode. In the capacitance mode, there is a digit after decimal; unit: mm; in
and the height value flashes, it is the high
and the height value flashes, it is the low
and display, it is the upper limit position.
and display, it is the lower limit position.
; the last 3 digits display the parameter value in the
and ; manual rising: ; manual