The Communication Interface Of The Cnc System Is Used To Complete The Operation (Rs232 Communication Mode); Operation Flow - MicroStep SH-HC30 System Manual

Usually, I / O of the numerical control system is in the manual control mode of the height controller. When
the processing starts, I / O of the numerical control system converts to the automatic control mode of the
height controller. Now the mechanical lifting device of the height controller realizes the automatic height
control.
4.3 The communication interface of the CNC system is used to
complete the operation (RS232 communication mode)
The function is being developed. For the final functions see the additional remarks after the functions are
completed.

4.4 Operation Flow

arc voltage type
For mechanical
installation see 3.1;
connection of
For electrical installation
of arc voltage see 3.3
Electrify,
detection mode is
set
Figure 4-1 The operation flow using or needing the replacement of detection mode for the first time
Page 19
SH-HC30 Height Controller System Manual
the
as the arc
Flow starts
detection moden
The flow is
capacitive type
For mechanical
installation see 3.1;
connection of capacitance
For capacitance electrical
installation see 3.2
Electrify, the
detection mode is
set as the