JVC HR-S9400EE Instructions Manual page 47

• •
• • • •
• • • •
• • • •
• • • •
• • • •
PU SH JO G
To M a k e Corrections . . .
. . . during step 8 or 9 , you can cancel registered in and out
points by pressing CAN CEL on the remote control. Each time
you press, the preceding point is erased.
● If, for example, you have registered 5 sets of in and out points
and want to reset the first set, you have to press CAN CEL until
all points after the first set have been erased. Reenter them
after you've repaired the first set of points.
M em ory Ca pa city
Random Assemble Editing shares
memory space with the recorder's
timer. If there are programs
occupied by timer-recording data,
those spaces cannot be used to
register edit-in and -out points —
meaning you won't be able to edit
8 scenes.
● When all 8 programs are full,
"PROGRAM FULL" appears on the R.A. EDIT screen.
● To cancel a program, see page 34.
Downloaded from: https://www.usersmanualguide.com/
8
PROGRAM FULL
0:00:00
(+) 0:00:00
[MENU] : EXIT
LO CATE EDIT -IN PO IN T
8
Find the point on the source
tape from where you want
the edited scene to begin by
pressing PUSH J OG
using the TIM E SCAN
SH U TTLE ring or the JO G
dial, then press IN/ OUT .
● The edit-in point is
registered in memory
and appears on the screen.
● You can also perform an Index Search (if index marks
have been previously recorded on the tape at the
desired points) to find the points you want, but this
will result in reduced accuracy.
LO CATE EDIT -O UT PO IN T
9
Find the point where you
want the edited scene to
end by pressing PU SH
or using the
JO G
TIM E SCAN SH U TTLE ring
or the JO G dial, then press
IN/ O UT .
● The edit-out point is
registered in memory
and appears on the
screen.
● The total time of the
edited scenes is displayed
to the right of "(+)".
● Repeat steps 8 and 9 for
each additional scene.
PREP ARE RECORDIN G DECK
10
Engage its Record-Standby mode.
ST ART R.A. EDIT
11
Press START .
● Automatic editing begins; all the specified scenes are
copied to the recording deck in the order they were
registered.
● The on-screen display remains while your recorder
searches for each scene (blinking cursor indicates
scene currently being searched for), but disappears
during actual editing.
● During scene search, the recording deck automati-
cally enters its Record-Standby mode.
● When all registered scenes have been edited, your
recorder enters the Pause mode, the recording deck
enters its Record-Standby mode, and the cursor blinks
at the next available number
47
EN
= 1
2
3
4
or
5
6
7
8
0:00:00
(+) 0:00:00
[MENU] : EXIT
0:02:23
=1
2
3
4
5
6
7
8
0:02:23
(+) 0:00:00
[MENU] : EXIT
0:02:23 0:02:51
=1
2
3
4
5
6
7
8
0:02:51
(+) 0:00:28
[MENU] : EXIT
CO N TIN U ED O N N EXT PAGE.