Unigas E115X Installation Manual page 22

BURNERS WITH INVERTER VARIANT (if provided)
INVEOR M
The manufacturer provides:
KOSTAL: on-board or wall-mounted (in the latter case the kit is required)
DANFOSS: wall-mounted
Both can be equipped with a braking resistor.
The burner terminal box is prepared to receive certain signals (for connection to the inverter, see the dedicated connection diagram).
Input signals for the inverter depending on the equipment:
LMV51.300 / LMV52.xxx
HAGC31-CU01
LMV37.400 / LMV26.300
The LMV51.300 / LMV52.xxx, HAGC31-CU01 e LMV37.400/LMV26.300 electronic cam burners with fan motor driven by inverter in
addition to the air and fuel adjustment curves also have a fan motor speed adjustment curve.
Generally the curve of the inverter goes from 50% to 100% of the engine revolutions. This, in addition to improving the setting of the
burner also allows a saving on the consumption of the fan engine.
Terminal interface with Inverter
LMV5
PART III: INSTALLATION
DANFOSS FC101
DANFOSS FC102
4÷20mA
4÷20mA
0÷10V
Braking resistances
- HAGC31-CU01
possibility of use only for
possibility of use
only for
INVEOR
LMV2x/3x
22
FC102