Table of Contents
Advertisement
A:If memory management software e.g. EMM386 has been
installed, you have to reserve some areas in upper memory
(C000:0 -- EFFF:F) for attribute memory of PCMCIA card
during enabling the card.
Example:Device=C:\DOS\EMM386.EXE RAM X=D000-
D3FF.
Reserve D000 - D3FF for attribute memory.
C:No free I/O space or interrupt request can be assigned to the
PCMCIA card.
A:The LAN/Modem card needs 32 contiguous I/O ports and
one interrupt request for LAN. It also need 8 contiguous I/O
ports and another interrupt request for Fax/Modem. The
LAN ports have to be located at one of the following I/O
space. 0x300, 0x320, 0x340, 0x360. The Fax/Modem ports
have to be located at one of the 0x2F8, 0x3E8, 0x3E8.
Besides for the compatibility consideration with some of the
Fax/Modem applications. The Modem interrupt (MIR) is
recommended to be assigned at value less than 7 (IRQ3 to
6). Make sure that the resources are available for the
LAN/Modem card.
Q:How can I know the LAN/Modem card has been
enabled or not ?
A:If the Card Service is installed, you can check by hearing
the beep when card insertion.
A:Run CARDEN /CHK to check, if the card has been
enabled. The resources allocated for the card are shown as
below at the last line of display message.
" IOP=0Xnnn IRQ=nn COM=nn MIR=nn"
Q: How to install the Win 95 driver over SystemSoft
CardWorks ?
PLANET ENW-3503 User's Manual
5 Q & A
5-7
Advertisement
Table of Contents
