Table of Contents
Advertisement
2 INSTALLATION
Card might be confirmed. Answer the questions
accordingly.
17. Connect to your network using the provide
10Base-T cord with 8-pin RJ-45 plug.
18. Reboot the system.
Getting Start for Windows NT4.0
1. Remove all existing PC Cards from the system.
2. Run Windows NT 4.0
3. Login with a full access level i.e.
ADMINISTRATOR
4. Remove all existing network support from
MY COMPUTER à CONTROL PANEL à
NETWORK à ADAPTERS
5. Press CLOSE after all network components are
removed.
6. Remove all serial port devices in
MY COMPUTER à CONTROL PANEL à
PORTS
7. Press CLOSE after all serial port devices are
removed.
ENW-3503 PC Card Installation in NT 4.0
1. Insert ENW-3503 PC Card into one of the PCMCIA Slots
2. Start Windows NT 4.0
3. Login with a full access level
ADMINISTRATOR
4. Open MY COMPUTER à CONTROL PANEL à
NETWORK.
If Network has not been installed,
♦ select YES to start Network installation,
♦ press Next and press SELECT FROM LIST button, then
press HAVE DISK button,
♦ insert the Ethernet + Fax/Modem driver disk into drive
floppy disk drive, then enter the correct path.
2-10
LAN + Fax/ Modem PC Card
Advertisement
Table of Contents
