Table of Contents
Advertisement
Return <CR> character used as the
command line and result code terminator.
Pertain to asynchronous operation only
S4= 0-127
Hold the decimal value of the character
recognized as a line feed. The line feed
control character is output after the
carriage Return control character if
verbose result code are used.
S5= 0-32
Hold the decimal value of the character
recognized as 127 a backspace. The
modem will not recognize the backspace
character if this register is set to a value
greater than 32.
S6=
Set the length of time, in seconds, that the
modem must wait (minimum 2 seconds
even if the value is less than 2) after going
off-hook before dialing the first digit of the
telephone number
S6=2-65
For international version
S6=4-65
For Japanese version
S7=
Set the time, in seconds, that the modem
must wait before hanging up because
carrier is not detected
S7=1-255
For international version
S7=35-59
For Japanese version
S8=0-65
Set the time, in seconds, that the modem
must pause when the "," dial modifier is
encountered in the dial string
S10=
Set the length of time, in tenths of a
1-255
second, that the modem waits before
hanging up after a loss of carrier
S11=
DTMF duration and inter digit delay. Set
the duration and spacing, in mini-
50-150
seconds, in DTMF touch tine dialing
PLANET ENW-3503 User's Manual
Appendix C
010
008
002
004
050
050
002
020
095
8-13
Advertisement
Table of Contents
