Table of Contents
Advertisement
Click this icon
and alias of signal could be put in if necessary.
Click this icon
to confirm the alias setting.
Layer
After signal is dragged into display, show Layer index Versus Signal index.
Numbers on Monitor
Numbers on monitor is to show how many layers at present allowed to put in the monitor.
(each neighboring monitor (5 and 6, 9 and 10) allows to put 8 layers, if there is no neighboring monitor in the
display area, the single monitor can contain 6+2 layers.
Cross over display will take up one more layer, as shown in the picture below.
Layer Adjustment
There are two ways to adjust layer.
1. Use the bar under the interface
Choose one layer and the bar shows its signal source, type in position and size.
© Xiamen RGBlink Science & Technology Co., Ltd.
Ph: +86 0592 5771197 | support@rgblink.com | www.rgblink.com
29
Advertisement
Table of Contents
