Revo RU8NVR2AX User Manual page 27

a. On the IP device's Web interface, go to Setup > Network > DDNS,
enable DDNS, select EZDDNS, set a domain name and get the
server address.
NOTE!
After setting the domain name, check that you can use the device address

to access the IP device's Web interface.
Make sure the EZDDNS server and the NVR are connected (ping the

EZDDNS server from the NVR).
b. On the NVR: Select a protocol, enter the above-mentioned server
address, domain name, username and password.
c. Click OK.
By a domain name

a. On the IP device's Web interface, go to Setup > Network > DDNS,
enable DDNS, select DynDNS or NO-IP, enter the domain name
that you have signed up on the DNS website, enter the username
and password, and then click Save.
b. On the NVR: Select a protocol, enter the domain name
mentioned above, enter the username and password. The port is
the external port of the IP device.
c. Click OK.
NOTE!
If Custom is selected for Protocol, the port is the mapped external RTSP

port of the IP device.
Do not add an IP device to an NVR using different methods (e.g., IP and

EZDDNS) at the same time.
When an IP device is added by EZDDNS, domain name (NO-IP or DynDNS),

or IP (public IP+public port) and it is not connected to the same router as
the NVR, alarm is configurable, but alarm push is not available.
27