Revo RU8NVR2AX User Manual page 25

Connect an IP camera to a PoE port or a switching port with a network
cable. The connected camera will be added to the NVR automatically.
Check status under Camera > Camera > Camera.
from the camera is available. Click
If the camera is connected via a network switch, click
Config in the window displayed, set Add Mode to Manual and then
complete the settings correctly.
NOTE!
appears under Status if the power output from a PoE port is below
or above the rated power of the connected camera.
Option 2
Click Camera > Camera > Camera. The system automatically
searches for IP devices and lists the discovered.
(Optional) To search a specified network segment, click Search
Segment and then set the address range.
You may choose one of the following ways to add an IP device:
Click Add All to add all the discovered IP devices allowed (depending

on channels supported by the NVR).
Click Custom Add. In the window displayed, enter the IP address and

complete other settings, and then click Add. You may also click
Search Segment and add discovered cameras in the list.
to view live video.
25
means live video
under Cam