Using a nanoSIM Card
IT-G600/IT-G650 supports nanoSIM cards.
To use WAN functions, a nanoSIM card must be installed.
The nanoSIM card slot is located in the battery pack compartment, so you must remove the
battery pack before installing or removing a nanoSIM card.
Installation
1. Turn the terminal off (shutdown).
2. Remove the battery pack.
(Steps 5 and 6 in the battery pack replacement procedure on page 21)
3 Push in the stylus (opposite end) in direction
direction
nanoSIM card slot
4 Install the nanoSIM card in the nanoSIM card tray, as shown in the fi gure.
28
.
and remove the nanoSIM card tray in
Push here with the stylus
nanoSIM card tray
Push down with the
stylus until the tray
slides out to the
position indicated
by the " ".