Pcie Mezzanine Card - Dell E01B002 Owner's Manual

Figure 13. Installing the memory module
a. memory module
b. alignment key
c. memory module socket ejector (2)
Next steps
1. Install the cooling shroud.
2. Follow the procedure listed in the After working inside your system section.
3. Press F2 to enter System Setup, and check the System Memory setting.
The system should have already changed the value to reflect the installed memory.
4. If the value is incorrect, one or more of the memory modules may not be installed properly. Ensure that the memory module
is firmly seated in the memory module socket.
5. Run the system memory test in system diagnostics.
Related references
Safety instructions on page 48
Related tasks
Before working inside your system
Removing the cooling shroud
Installing the cooling shroud
After working inside your system
Removing memory modules

PCIe mezzanine card

The sled supports one x8 PCIe Gen3 mezzanine card. The PCIe card provides an interface between the sled and external
storage devices.
NOTE: Ensure that the PCIe mezzanine card is set to Enabled in System Setup.
62 Installing and removing sled components
on page 48
on page 52
on page 53
on page 49
on page 60