Table of Contents
Advertisement
INSTALLATION
Connect the scanner to the host (terminal) using the interface (I/F)
cable, as shown in the following figures. A cable from an older existing
installation can be re-used for RS-232 interfaces. If external power is
used/needed, plug the AC Adapter into the AC wall outlet, then connect
it to the unit as shown in
The USB AUX PORT will only be supported by using a 12V power supply
or using a USB + POWER 12V port. If the scanner is powered only by the
standard USB cable as shown in
will not be supported.
After the scanner has fully powered up and indicates that it is ready for
operation, scan some known-good bar code samples to verify correct
operation. The scanner should beep and/or flash its good read LED
send the bar code data to the host or terminal. If not, use the
Troubleshooting section of this guide to identify any problems.
Figure 4. USB + Power Cable Power Off the Terminal
Power
1. Beeper and LED behavior may have previously been configured as "disabled"
by another user.
Figure 5 on page
Figure 6 on page
RJ Host Port
Connector
USB + Power Cable
Power Off the Terminal (POT)
4.
4, an auxiliary scanner
Terminal (PC)
QUICK REFERENCE GUIDE
and
1
3
Hide quick links:
Advertisement
Table of Contents
