Panasonic KX-TG2000B Operating Instructions Manual page 99

Problem
When a second call is
received on the same line,
the unit does not display
the new caller's
information.
You cannot redial the last
number dialed.
You cannot have a
conversation using the
handset.
You cannot have a
conversation using the
headset.
"Recharge" is displayed,
" " flashes or the unit
beeps intermittently.
You charged the battery
fully, but "Recharge" is still
displayed and/or "
still continues to flash.
The CHARGE indicator
light does not go out after
the battery has been
charged.
• If another call is received on the same line
while;
– the Automated Attendant System or
Answering System is responding to a call,
or
– a call is placed on hold,
the caller information will not be displayed.
• The line mode selection is incorrect. See
page 55.
• If the last number dialed was more than 32
digits long, the number will not be redialed.
• Access numbers entered after pressing
will not be included when redialing.
(TONE)
• The
(REDIAL)
button. It will redial the last
(PAUSE)
number dialed if pressed at the outset of a
call (p. 29). If another number has been
dialed first, it will operate as a pause button
(p. 46).
• When the headset is connected (p. 88), you
must use the headset to talk with the caller.
To have a normal cordless phone
conversation, disconnect the headset.
• Make sure that the headset is plugged into
the headset jack properly (p. 88).
• Charge the battery fully (p. 16).
• Clean the charge contacts and charge
again (p. 16, 17).
• Install a new battery (p. 90).
"
• This is normal.
Remedy
button also functions as the
99