Panasonic KX-TG2000B Operating Instructions Manual page 97

With the cordless handset
Problem
The unit does not work.
"No link to base.
Walk closer to
base & try again" is
displayed and an alarm
tone sounds.
Static, sound cuts in/out,
fades. Interference from
other electrical units.
The unit does not ring.
You cannot dial.
The display is blank.
You cannot program
function items, such as the
line selection.
• Charge the battery fully (p. 16).
• Clean the charge contacts and charge
again (p. 17).
• Install the battery properly (p. 90).
• Re-install the battery and place the handset
on the charger (p. 90). Try again.
• The handset has not been registered to the
base unit. Register the handset (p. 19, 53).
• You are too far from the base unit.
Walk closer to the base unit and try again.
• Raise the base unit antenna.
• Locate the cordless handset and the base
unit away from other electrical appliances
(p. 4).
• Walk closer to the base unit.
• Raise the base unit antenna.
• The ringer volume is set to OFF. Select
HIGH or LOW (p. 22).
• If 2 other handsets or the base unit and
another handset are in use, the unit may
not ring. The handset and base unit users
will hear incoming call tones.
• The handset is removed from the ring group.
Add to the ring group (p. 23).
• The dialed number is restricted. To cancel,
see page 51.
• Key lock mode is set. Cancel the mode by
pressing and holding
• Charge the battery fully (p. 16).
• Programming is not possible while in the
talk or intercom mode, or while listening to
messages.
• Do not pause for over 60 seconds while
programming.
• Make sure that the handset is in the
standby mode.
Remedy
(FUNCTION)
.
97