Install Anti-Tip Bracket; Adjust Leveling Legs - Jenn-Air RISE JGS1450ML Owner's Manual

Install Anti-Tip Bracket

WARNING
Tip Over Hazard
A child or adult can tip the range and be killed.
Install anti-tip bracket to floor or wall per installation
instructions.
Slide range back so rear range foot is engaged in the
slot of the anti-tip bracket.
Re-engage anti-tip bracket if range is moved.
Do not operate range without anti-tip bracket installed
and engaged.
Failure to follow these instructions can result in death or
serious burns to children and adults.
Remove the anti-tip bracket from the inside of the oven.
1.
Determine which mounting method to use: floor or wall. If you
2.
have a stone or masonry floor, you can use the wall mounting
method. If you are installing the range in a mobile home, you
must secure the range to the floor. This anti-tip bracket and
screws can be used with wood or metal studs.
Determine and mark centerline of the cutout space. The
3.
mounting bracket can be installed on either the left-hand or
right-hand side of the cutout. Position mounting bracket
against the wall in the cutout so that the V-notch of the bracket
is 12 1 / " (31.8 cm) from centerline, as shown.
2
A. 12 1 / " (31.8 cm)
2
B. Bracket V-notch
12
Drill two 1/8" (3 mm) holes that correspond to the bracket
4.
holes of the determined mounting method. See the following
illustrations.
Floor Mounting
Rear position
Wall Mounting
Using the two #10 x 1 5 /
5.
provided, mount anti-tip bracket to the wall or floor.
Move range close enough to opening to allow for final
6.
electrical connections. Remove shipping base, cardboard or
hardboard from under range.
Move range into its final location, making sure rear leveling leg
7.
slides into anti-tip bracket.
Move range forward onto shipping base, cardboard, or
8.
hardboard to continue installing the range, using the following
installation instructions.

Adjust Leveling Legs

1. If range height adjustment is necessary, use a wrench or
pliers to loosen the four leveling legs. This may be done with
the range on its back or with the range supported on two legs
after the range has been placed back to a standing position.
NOTE: To place range back up into a standing position, put a
sheet of cardboard or hardboard in front of range. Using two
or more people, stand range back up onto the cardboard or
hardboard.
2. Measure the distance from the top of the counter to the floor.
Front position Diagonal
(2 options)
" (41 mm) Phillips-head screws
8