Table of Contents
Advertisement
Close the battery door. Make sure the gasket (around the battery compartment) is
properly seated in its trace prior to closing the door. Tighten the set screw.
Note: Do not install the batteries backwards. You can permanently damage the sensors.
The solar panel does not charge the batteries, so rechargeable batteries are not needed or
recommended.
Note: We recommend installing Lithium AA batteries for sensors.
The sensor LED indicator will light for 3 seconds, and then flash once per 16 seconds
thereafter. Each time it flashes, the sensor is transmitting data.
Replace the battery door and push to tighten it.
Note: If the sensor does not power up after inserting the batteries, press the reset button
shown in Figure 6.
Figure 5
5
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the FT-0310 and is the answer not in the manual?
Questions and answers
Top left outdoor temperature showing dashes. Have reset everything and added new batteries etc but still no good. However bottom right is working on ch 1.
The top left outdoor temperature on the Sainlogic FT-0310 may display dashes due to signal issues between the remote sensor and the display console. Possible reasons include:
1. The remote sensor is too far from the display console.
2. There is interference from electrical devices like computers or TVs.
3. The sensor needs time to stabilize (up to one hour).
4. The sensor is not positioned properly (e.g., blocked by obstacles).
Solutions:
- Move the sensor closer to the console.
- Reduce interference from electronic devices.
- Allow time for the sensor to stabilize.
- Ensure the sensor has fresh batteries.
This answer is automatically generated