Executing A Programming Project In Standalone Mode - Equinox Systems EPSILON5 MKII User Manual

Distributor of Equinox Technologies: Excellent Integrated System Limited
Datasheet of EPSILON5-A1 - ISP PORTABLE PROGRAMMER USB
Contact us: sales@integrated-circuit.com Website: www.integrated-circuit.com

2.6.4 Executing a Programming Project in Standalone Mode

# Action
1 Connect the programmer to a spare PC COM
port
2 Apply power to the Programmer / Target
System
See section 3 for Power Supply scenarios
3 Upload your 'Programming Project(s)' to the
programmer
4 Disconnect power from the Programmer /
Target System
5 Disconnect the serial lead from the
programmer
6 Follow relevant instructions in section 3 to
program a Target Device.
For detailed instructions of operating the programmer in Standalone Mode, please refer to the
relevant sections of the manual as detailed in the table below:
# Power Supply Scenario
1 Power Supply Schematic Overview
2 Earthing requirements
3 Programmer powers the Target System
4 Target System powers the Programmer
5 Programmer and Target System are
independently powered
34
Observation / comment
Programmer Target Vcc LED illuminates
To upload 'Programming Project(s)' to the
programmer:
•
Locate your Project Collection (*.ppc)
file.
•
Click the <Upload< icon
•
Follow the on-screen instructions to
upload your Project Collection to the
programmer.
•
Your Project(s) are now resident in
the memory of the Programmer.
•
See EQTools Manual – Project
Upload Wizard for full instructions.
All uploaded Programming Projects will be
retained by the programmer in on-board non-
volatile FLASH memory.
Programmer is no longer controlled from PC
The instructions to program a device in
'Standalone Mode' differ depending on how the
programmer and Target System are powered.
Jumper J9
-
-
FITTED
FITTED
NOT FITTED 3.1 – 5.0
EPSILON5 MKII Programmer - User Guide V1.12 – 1
The <Upload Wizard> utility will
launch
Voltage (V) Refer to section
- 3.2
- 3.3
3.1 – 5.0 3.4
3.1 – 5.0 3.5
3.6
st
August 2007