Table of Contents
Advertisement
Distributor of Equinox Technologies: Excellent Integrated System Limited
Datasheet of EPSILON5-A1 - ISP PORTABLE PROGRAMMER USB
Contact us: sales@integrated-circuit.com Website: www.integrated-circuit.com
1.5 Programmer Specifications
1.5.1 Programmer Specifications Overview
The table below details the hardware specifications for the programmer. Please refer to the stated
section for further information about any specific parameter.
#
Parameter
1
Target Device
Support
2
Target Device
Programming
Interfaces
3
Operating modes
4
On-board FLASH
Memory Store
5
Project storage in
Memory Store
6
Keypad entry
7
Status LED's
8
Target Vcc
Voltage Detection
LED
EPSILON5 MKII Programmer - User Guide V1.12 – 1
Description / comment
See Device Support List
The programmer supports the following programming
interfaces:
•
Atmel Low Voltage SPI
•
Atmel High Voltage SPI (+12V Vpp)
•
Atmel AVR JTAG (chargeable update)
•
Atmel (formerly Temic) 8051 Boot loader ISP
NXP (Phillips) 8051 - Boot Loader ISP
The programmer supports the following operating modes:
As standard:
•
Development Mode (PC controlled)
•
Project Upload Mode using Upload Wizard (PC
controlled)
•
Standalone Mode - Keypad + LCD operation
•
Standalone Mode – Run Target
•
ConsoleEDS EVAL – Command Line control
Optional chargeable upgrades:
•
Standalone Mode - Remote Controlled via 'ASCII Text
Communications' RS-232 Serial Protocol
•
PC controlled via ISP-PRO software (chargeable
upgrade)
ConsoleEDS PRO – Command Line control
2 Mbits (256 kBytes) FLASH Memory
1 x Programming Project
or 2 x 'Chained Projects'
2 x Push Button - <YES> and <NO>
3 x Status LED's - <PASS>, <BUSY>, <FAIL>
•
Target Vcc (POWER) LED will light when Target Vcc is
detected.
•
Threshold detection voltage: approx 3.1V
st
August 2007
Refer
to
section
1.6.1
1.6.2
2.4
5
Advertisement
Table of Contents
