Table of Contents
Advertisement
Distributor of Equinox Technologies: Excellent Integrated System Limited
Datasheet of EPSILON5-A1 - ISP PORTABLE PROGRAMMER USB
Contact us: sales@integrated-circuit.com Website: www.integrated-circuit.com
2.5 Development Mode (EDS)
2.5.1 Overview
In 'Development Mode', the programmer is controlled from the EQTools – EDS (Equinox
Development Suite) running on a PC. The Development utility is called Equinox Development Suite or
EDS for short. In this mode it is NOT necessary to upload the 'Programming Project' to the
programmer as the EDS utility co-ordinates all programming operations.
In EDS Mode, you can perform the following actions under PC control:
•
Write data directly to a Target Device from the PC e.g. a HEX file
•
Read data from a Target Device to a file on the PC
•
Write / Read the Configuration Fuses of a Target Device
•
Write / Read the Security Fuses of a Target Device
•
Read the Target Vcc Voltage
2.5.2 Creating a new EDS (Development Mode) Project
To test a Target Chip in EDS (Development Mode), follow the instructions detailed below:
•
Launch EQTools
•
From the Welcome Screen, select the 'Create a new Equinox Development Project (EDS)'
option.
OR
•
From the left-hand pane, select the <Development> tab and then select 'New Development
Project'.
The EDS Wizard will now launch
•
Follow the EDS Wizard by filling in each tab and then clicking the <Next> button:
•
Select Programmer – click <Get Info> button to detect your attached programmer
•
Select Project Type – leave as the default 'Standalone Keypad Operation'
•
Select Device – This is your Target Chip.
•
Select Target Oscillator – If unsure of settings leave all settings as the defaults and click
<Next>.
•
Select Target Voltage
•
Select FLASH Data File (optional – you can enter the file name at a later stage in EDS)
•
Select EEPROM Data File (optional – you can enter the file name at a later stage in EDS)
EPSILON5 MKII Programmer - User Guide V1.12 – 1
st
August 2007
27
Advertisement
Table of Contents
