Equinox Systems EPSILON5 MKII User Manual page 18

Distributor of Equinox Technologies: Excellent Integrated System Limited
Datasheet of EPSILON5-A1 - ISP PORTABLE PROGRAMMER USB
Contact us: sales@integrated-circuit.com Website: www.integrated-circuit.com
9 PC Control Software The programmer can be controlled using:
10 PC requirements
11 Power Supply
Options
12 Voltage range
13 Vpp Voltage
Generator
14 DC Power Connector
(CON1)
15 Programmer Current
Consumption
16 Max. current through
programmer
17 Target SPI
Frequency
18 Target UART Speed
6
•
EQTools (as standard)
•
ISP-PRO (chargeable upgrade)
•
Standalone Upload Wizard (chargeable upgrade)
•
ConsoleEDS Evaluation version
•
ConsoleEDS PRO (chargeable upgrade)
•
ASCII Text Mode (chargeable upgrade)
PC running Windows 95 / 98 / 2000 or ME / NT4 / XP
There are 3 possible modes for powering the Programmer /
Target System:
•
Programmer powers Target System
•
Target System powers the Programmer
•
Programmer and Target System are independently
powered
See specified section
On Board +12.0V Vpp Voltage Generator
(Applies +12.0V to RESET pin for ATtiny HV programming)
•
DC Power Connector
•
2.5 mm Jack Socket – Centre Positive
•
DC Power Lead supplied with programmer – white
stripe is +ve.
This refers to the current consumption of the actual
programmer circuitry. See specified section.
This refers to the maximum current which can be supplied
through the programmer from CON1 (i.e. external power
supply) to the Target System.
Max current = 300 mA.
Software SPI algorithm:
•
SLOW SPI: 0 – 490.2 kHz (user selectable)
•
MEDIUM SPI: 0 – 490.2 kHz (user selectable)
( SPI speeds are estimations only due to uneven mark/space
ratio and non-continuous waveforms)
Hardware SPI algorithm (requires firmware 3.04 or
greater):
•
SLOW SPI: 115.2 kHz to 921.6 kHz (user selectable)
•
FAST SPI: 115.2 kHz to 921.6 kHz (user selectable)
This is the Communications Speed (BAUD rate) from the
programmer to the Target Device when communicating via a
Boot Loader. The BAUD rate is configurable from 1,200 to 115
kBaud. This settings is completely independent from the BAUD
rate settings for the PC communicating with the programmer.
EPSILON5 MKII Programmer - User Guide V1.12 – 1
2.3
3.0
1.5.2
1.5.2
1.5.3
1.5.3
4.0
st
August 2007