Equinox Systems EPSILON5 MKII User Manual page 32

Distributor of Equinox Technologies: Excellent Integrated System Limited
Datasheet of EPSILON5-A1 - ISP PORTABLE PROGRAMMER USB
Contact us: sales@integrated-circuit.com Website: www.integrated-circuit.com
7 Select the required ISP Header and then plug
the ISP Cable into this Header.
Please refer to section 4.
8 Apply power to the programmer
Connect 3.0-5.0V to CON1 via supplied lead
(white stripe is +ve)
or
Fit J9 and connect ISP Cable to powered
Target System
Please refer to section 3 for further details.
9 Remove power from programmer
10 Re-fit lid to programmer
11 Re-fit the four screws in the back of the case
12 Ensure that the PC, programmer and Target
System power is switched OFF.
13 Connect the PC serial cable to the
programmer RS-232 port (J5) and connect
the other end of the cable to a spare PC
COM port.
See section 1.5.6 for Serial Cable
specifications.
14 Connect the ISP cable to the ISP Header on
your Target System
20
programmer firmware is being updated.
!!! WARNING !!!
•
If you select the wrong ISP Header
then it is possible that you may
damage both the programmer and
Target System when power is
switched on.
•
Please ensure you are using the
correct header. If in doubt, please
refer to section 4 of this manual and /
or contact Equinox Support for
assistance.
Programmer circuitry powers up to 3.0V.
If the Jumper Link J9 is fitted then the 'Target
Vcc' LED will illuminate.
All LED's go out
The ISP Cable should fit through the slot in the
end panel.
EPSILON5 MKII Programmer - User Guide V1.12 – 1
st
August 2007