Table of Contents
Advertisement
INTRODUCTION
Thank you for choosing a product from Kellfri AB. Compliance with the safety instructions, operating
manual and sound common sense will guarantee many years of enjoyment using the product.
Kellfri's equipment and products are aimed at self-employed farmers, horse enthusiasts and other
country-dwellers who have stringent performance demands.
PRODUCT INFORMATION
The WKL180 has a robust and powerful design and a working width of 1.8 m. Customised for 50-75 hp
tractors. The gearbox has a freewheel for gentle shutdown of the mower.
The mower has a coarse-toothed welded counter bar in the chassis to break up the grass more
effectively, and detachable counter blades to keep the grass in the machine and enable more
material to be cut.
The cutting height is adjusted by the support roller and skids. The adjustable support roller
guarantees a correct cutting height on uneven ground. The cutting height can be adjusted between
0-120 mm, enabling you to cut the grass close to the ground and thus achieve a more level result.
The grass is evened out and the remnants moulder away faster. The support roller has a scraping
iron to keep the roller free from cut material.
The front of the verge flail mower is fitted with chain guards that adapt to the substrate and protect
both the tractor and the surroundings from stone chipping and grass spray. High level of safety with
collision protection that angles the machine upwards if you hit a stump, for example.
The verge flail mower is fitted as standard with hammer flails.
The hydraulic side shift adjustment enables you to shift the machine to the left or right. The side
shift adjustment means that you can cut at the side of your tractor and thereby reach ditch edges
and the median strip of roads, which would otherwise be difficult to reach. The hydraulic side shift
adjustment enables you to drive with just one pair of wheels in the uncut area and cut closer to
ditches, fences, etc. The maximum side shift adjustment of the machine is 334 cm to the right from
the mid-point of the tractor.
The mower has an openable flap. You open the flap when you know you are cutting or topping
ground that generates a higher flow of material. This enables you to drive freely under the same
conditions as with a closed flap and a normal flow of material. You save on fuel and reduce wear on
the belts, and you can also operate at a higher speed, as the grass does not become twisted around
the roller. The grass is also spread more evenly.
The machine's cutting head can be angled 90° upwards and 60° downwards.
TECHNICAL DATA
Length x width x height
Working width
Operating height
Power requirement
Operating speed
Hammer flails
3-point linkage
Side shift adjustment
RPM
Weight
Table of Contents
35-WKL180
2260 x 975 x 701 mm
1800 mm
0 - 120 mm
50 - 75 hp
6 - 12 km/h
24 (Y-flails can be purchased additionally - not included.)
Cat 2
Hydraulic
540 rpm
654 kg
3
Advertisement
Table of Contents
