Picture Problem - Eizo RadiForce MX217 Instructions For Use Manual

3 | No-Picture Problem
3 No-Picture Problem
Power switch indicator does not light up
• Check whether the power cord is connected properly.
• Turn the main power switch on.
• Touch .
• Turn off the main power, and then turn it on again.
Power switch indicator lights up: Green
• Increase "Brightness", "Contrast", or "Gain" in the Setting menu (cannot be adjusted in
1-DICOM, 2-CAL1, 3-CAL2 modes). For details, refer to the Installation Manual (on the
CD-ROM).
• Turn off the main power, and then turn it on again.
Power switch indicator lights up: Orange
• Switch the input signal. For details, refer to the Installation Manual (on the CD-ROM).
• Move the mouse or press any key on the keyboard.
• Check whether the PC is turned on.
• Check whether the signal cable is connected properly. Connect to the DisplayPort input
connector when inputting a DisplayPort signal. The DisplayPort output connector is used
for output when a daisy-chain connection is set up.
• Turn off the main power, and then turn it on again.
Power switch indicator blinks: Orange, Green
• Connect via the signal cable specified by EIZO. Turn off the main power, and then turn it
on again.
• If the signal cable is connected to DisplayPort, try switching the DisplayPort version. For
details, refer to the Installation Manual (on the CD-ROM).
The message "No Signal" appears in the screen.
Example:
• The message shown above may appear, because some PCs do not output the signal
immediately after power-on.
• Check whether the PC is turned on.
• Check whether the signal cable is connected properly. Connect the signal cables to the
connectors of the corresponding input signal.
• Switch the input signal. For details, refer to the Installation Manual (on the CD-ROM).
• If the signal cable is connected to DisplayPort, try switching the DisplayPort version. For
details, refer to the Installation Manual (on the CD-ROM).
24