Table of Contents
Advertisement
2 | Installation / Connection
Attention
• Visit the EIZO web site for information about monitors and graphics boards that can be used for
the daisy-chain connection:
(www.eizoglobal.com)
• To set up a daisy-chain connection, make sure that "DisplayPort" in the Administrator Settings
menu is set to "Version 1.2". For details, refer to the Installation Manual (on the CD-ROM).
• Remove the DisplayPort output connector cap before connecting the signal cable.
Connect to PC
Signal cable: PP300
2. Plug the power cord into a power outlet and the power connector on the monitor.
Insert the power cord fully into the monitor.
3. Connect the USB cable to the monitor's USB upstream port and to the PC's USB
downstream port respectively.
The cable connection is required when you use RadiCS / RadiCS LE or when you
connect a USB device (USB-connected peripheral device) to the monitor.
2.3 Turning On the Power
1. Touch
to turn on the power to the monitor.
The power switch indicator of the monitor lights up green.
If the indicator does not light up, see
Note
• When you touch any of the operation switches excluding
starts flashing to let you know where the power switch is located.
22
Signal cable: PP300
USB cable: UU300
3 No-Picture Problem
[} 24].
with the monitor power turned off,
Advertisement
Table of Contents
