No-Picture Problem - Eizo RadiForce RX220 Instructions For Use Manual

No-Picture Problem

If no picture is displayed on the monitor even after the following remedial action is taken, contact your
local dealer.
1. Check the Power indicator.
Symptom
No picture
2. Check the error message that remains on the screen.
These messages appear when the input signal is incorrect even if the monitor is functioning.
Symptom
6
Status
Power indicator does not
light up.
Power indicator lights green.
Power indicator lights
orange.
Status
The input signal is not
received.
The signal frequency is
outside the specification.
Incorrect signal frequency is
shown in red.
Possible cause and remedy
• Check whether the power cord is connected correctly.
• Turn off the main power, and then turn it on again a
few minutes later.
• Turn the main power switch on.
• Press .
• Set each adjusting value in [Brightness], [Contrast]
and [Gain] to higher level.
• Switch the input signal with
• Press a key on the keyboard or click the mouse.
• Turn on the PC.
Possible cause and remedy
• Check whether the PC is turned on.
• Check whether the signal cable is properly connected
to the PC.
• Switch the input signal with
• Reboot the PC.
• Change the mode to an appropriate mode using the
graphics board's utility software. Refer to the manual
of the graphics board for details.
fD: Dot Clock
(Displayed only when the digital signal inputs)
fH: Horizontal Frequency
fV: Vertical Frequency
.
.