After-Market Front Camera - NavLinkz RL4-NAC12 Manual

2.5.3. After-market front camera

To display the images from the front camera camera, the video interface also receives the
data from the vehicle CAN bus. If, due to missing CAN bus data (as not all vehicles are
compatible), the analogue power connection was previously made, the corresponding
manual input signal by
For analogue connection, dont forget to set dip4 to OFF.
The green power supply output
If Dip 1 is set to ON (of the black 8 dips), the power supply output supplies +12V (max
3A) when the reverse gear is engaged ...
Note: In addition, a manual switch-over to the front camera input is possible via keypad
(short press) from any image mode. The power supply output supplies +12V then, too (if Dip
3 is set to ON and the front camera input is selected).
Version 29.11.2022
„Trig-FRONT" wire is also required here.
„Reverse-Out"
HW: BOT(V43)(V54)
can be used to power a front camera.
and additionally 10, 15 or 20 seconds
delay after reverse gear is
disengaged for the front camera.
RL4-NAC12