Settings Of The 8 Dip Switches - NavLinkz RL4-NAC12 Manual

1.5. Settings of the 8 Dip switches (black)
Some settings have to be selected by the 8 dip-switches at the
video-interface. Dip position down is ON and position up is OFF.
Dip Function
1 AV1-R input
2 AV2-L input
3 V3 Front camera input
4 Input signal
Video sources
5
Rear-view cam type
6
Guidelines
7 No function
8 Factory PDC
for after-market rear-
view camera
See the following chapters for detailed information.
*The front camera will automatically be switched for 10, 15 or 20 seconds (adjustable) after
disengaging the reverse gear.
The camera power supply +12V will automatically be provided by the green wire
when the reverse gear is engaged, plus 10, 15 or 20 seconds delay for the front camera, and
also +12V when the front camera is manually selected by external keypad (see chapter "Power
Supply Output").
**The display of the guidelines only works with simultaneous PDC display (Dip8 = ON).
After each Dip-switch-change a power-reset of the Can-box has to be performed!
Version 29.11.2022
ON (down)
enabled
enabled
enabled*
By trigger wires
after-market
Enabled**
enabled
HW: BOT(V43)(V54)
OFF (up)
disabled
disabled
disabled
By CAN
factory or none
disabled
Set to OFF
disabled
"Reverse-Out"
RL4-NAC12